WFC/5 FREQUENCY TO CURRENT CONVERTER    

The WFC/5 converts the pulsed output from your flowmeter into an analogue 4-20mA or 0-10V signal.


Quick and easy to install
Preset to your requirements
Highly accurate
Monitor consumption and flow rates
Improve your process
Reduce costs and waste
High quality manufacture
High reliability
Immunity to electrical noise

Application
The WFC/5 will convert a pulsed flowmeter signal into an analogue signal for instruments such as PLC’s, computers, flow controllers, chart recorders, indicators or moving coil meters.

Installation
The weatherproof, insulated, impact and chemically resistant enclosure allows the instrument to be installed almost anywhere. It can be mounted in a panel or on to a wall via integral holes in the case.

Instrument Function
The WFC/5 will accept any pulsed signal from a flowmeter. It provides you with two analogue outputs of 4 - 20 mA and 0 - 1 mA.
An unscaled (one to one) 5 V TTL pulse can also be used for instruments requiring a square wave pulsed input.
The instrument has a DC power supply for sensors.

Features
Overrun compensation: The controller can automatically compensate for errors caused by slow acting valves and deliver exactly the volume you want.
No flow alarm: If there is a problem and the signal from the flowmeter stops an alarm will be given and the batch will be stopped.
Linearisation: The accuracy of your system can be improved by programming any flowmeter errors into the BC7.
There is a non resettable total to allow you to monitor long term usage.

Construction
The Batch Controller is in a standard 1/4 DIN format to mount in a panel.
The front keypad is a sealed unit which provides you with a splash proof seal that is resistant to most chemicals.

Specification

 Input signals:

Click below to switch to the following flowmeters:
BC7 Batch Controller| RT7 Rate Totaliser |202 Rate Totaliser | 214i Batch Controller | RTB Rate Totaliser | WFC5 4-20 mA Converter | WS5 Flowmeter Scaler | FC7 F to I Converter | Sensors & Amplifiers |